Need to change a front wheel-bearing on a 97 Chevy Cavalier. The bearing is in a pre-assembled hub. I removed the three bolts holding the hub to the steering knuckle but couldn%26#039;t get the bearing out because it seemed to be rusted in there. I tried using Seafoam (rust remover) and that didn%26#039;t seem to change anything... and I have pretty well pried and hammered at it with small tools. What would a shop use to get it off? Please be specific if you know... like the name of tools or equipment and possibly where I can get them or rent them. Thanks!|||Keep on smashing at it with a larger sledge and keep putting the knocker loose to it. If you use heat you could damage the knuckle. Patience and a bigger sledge will prevail.
Good luck.|||with a hammer a rubber one called a mallet|||You need a Slide Hammer or your never going to get it off.
Subscribe to:
Post Comments
(Atom)
No comments:
Post a Comment