Do I need a press to change a front wheel bearing?

I have a 2005 chevy cobalt. Does any one know if I need a press to change a wheel bearing?|||On the front of your 2005 Chevrolet Cobalt, there is a hub assembly.


You can purchase these hub bearing assemblies from http://mibearings.com


You will not need a hydraulic press or any other press to install these hubs.|||Not familiar with your vehicle.





However on most you can Tap out the outer cones





or seats pressed into the hubs with a small punch





trapping gently around the inner protruding edges.





And tap back into place with hammer (If there%26#039;s space)





then finish off with a punch, double





check the bearing seats properly





though.





Good Luck.





Cheers Mars Mission.|||You probably will have to buy a wheel hub assembly, which will include bearings and abs sensors and will be bolted to the steering knuckle.





So in short, no.|||You can use a large socket and a hammer to get the old ones out. Press the new ones in after heating the shell to expand the metal. Too easy. You do not need a press.|||I suspect that this is a bearing and hub assembly - sold only as an assembly.


No press needed - just a Gold Master Card.